Can a gas insert be installed in my existing masonry fireplace?
Yes, and in Brevard we'll usually set that insert up for propane — this is LP country, out past the reach of the natural-gas mains. The unit drops into your existing masonry firebox, vents through a stainless steel liner, and burns clean once we dial in the right orifices and pressure. Your open hearth stops sending heat up the chimney and starts holding the room.
Wet-country flues need a look first
Transylvania County catches more than 80 inches of rain a year, and it's hard on masonry — cracked crowns, spalling brick, dampers rusted stiff, and clay flue liners that quietly degrade. Before we line a chimney for a gas insert, we confirm what's up there is sound, because the sealed liner has to run clean top to bottom. Around Connestee Falls and the cabins, chimney chases and crawl spaces take the worst of the moisture, so that inspection isn't a formality — it's where problems get caught.
Propane, done by the licensed crew
The tank itself we coordinate with your propane supplier; everything past it — the regulator, the piping, the appliance hookup — is licensed gas work, and in North Carolina a showroom or a mason legally can't touch it. We run and pressure-test the line, pull the Transylvania County permit, and meet the inspector. A sealed insert with millivolt or battery-backup ignition also keeps throwing heat when the power's out, which is no small thing up here, and it commonly runs 70% efficient or better against an open firebox that loses heat overnight. We're about 40 minutes southwest of the Asheville showroom — call (828) 545-0525 to set up a free in-home look.
Fireplace help in Brevard
We install and service fireplaces throughout Brevard and the rest of Transylvania County — just 40 minutes southwest from our Asheville-area showroom.
Related questions
- Does a gas fireplace insert need a chimney liner?
- How do you measure a fireplace to know if an insert will fit?
- Can a wood-burning insert be installed in my masonry fireplace?
- Do I need a chimney inspection before installing an insert?
- Does the damper get removed or clamped when installing a gas insert?