How does converting a wood-burning fireplace to gas actually work?
Out in Leicester, many homes run on propane and some remote properties have limited electrical capacity — which points a wood-to-gas conversion toward an appliance that needs no wiring at all. A millivolt insert or radiant gas fireplace makes heat with zero electricity, ideal here. We tune it for LP, run the licensed gas line, and permit the job with the county.
No power? No problem — the millivolt path
Leicester's rural large-property homes lean on propane and wood, and some of the more remote ones have limited electrical capacity to begin with. That's exactly where a Valor radiant unit shines: it runs on a millivolt pilot with no blower and no circuit board, so it keeps throwing warmth through a full grid-down week without drawing a watt. On clear winter nights the cold-air drainage here runs 5 to 8 degrees below Asheville, so heat that doesn't depend on the grid is genuinely useful, not just a nice idea.
Propane tuning, logs or insert
Most homes out here are on LP, so we set the conversion up for propane from the start — the right orifices and pressure, tank coordinated with your supplier. From there it's the usual fork: a sealed insert for real heat, or a vented log set for ambiance. Kozy Heat's cold-climate units are a natural fit for the winters.
Buncombe County permit, 15 minutes west
We run the line, pull the Buncombe County permit, pressure-test it, and meet the inspector — one accountable licensed contractor, 15 minutes west of the showroom. Call (828) 545-0525.
Fireplace help in Leicester
We install and service fireplaces throughout Leicester and the rest of Buncombe County — just 15 minutes west from our Asheville-area showroom.
Related questions
- How does a wood-to-electric fireplace conversion work?
- What's the difference between a gas insert and gas logs?
- Can you still burn wood in a fireplace after gas logs or a gas insert have been installed?
- Is a wood-to-gas fireplace conversion reversible if a future owner wants wood fires back?
- How does a gas fireplace insert vent through an existing chimney (co-linear venting)?