What size propane tank do I need to run a gas fireplace?
In Canton, put the tank where floodwater can't reach it — the Pigeon River valley has seen homes and gas appliances submerged, and that lesson shapes propane installs here. Capacity itself is simple: a fireplace on its own runs on a 120-gallon stationary tank. Placement and inspecting flood-exposed connections is the harder part.
After the flooding, connections get inspected
Valley homes that took on water had regulators, lines, and appliances that couldn't just be re-lit — submerged gas components have to be checked before anything runs again. When we install or reconnect a propane fireplace in the flood zone, we pressure-test the line and confirm every fitting downstream of the tank. Your propane supplier handles the tank itself; if it sat in water, that's their call to inspect or replace.
Placement over the flood line
Where the ground allows, siting the tank on higher ground — or planning a buried tank's location and anchoring around the valley's water table — keeps it out of trouble next time. Morning fog and valley damp also rust exposed fittings faster here, so above-ground hardware gets watched. A fireplace sips 20,000 to 40,000 BTU an hour, so it isn't the appliance driving tank size.
The numbers, then the permit
Share that tank with a furnace and water heater and you're at 250 to 500 gallons already, with the fireplace barely adding to it. We permit every line with Haywood County and meet the inspector. Canton's 20 minutes west — call (828) 545-0525.
Fireplace help in Canton
We install and service fireplaces throughout Canton and the rest of Haywood County — just 20 minutes west from our Asheville-area showroom.