Yes, though a Marshall manufactured home brings a wrinkle beyond the mobile-home listing: steep, tight sites make chimney routing and draft their own challenge. The stove still must be listed for manufactured-home use, with an outside-air kit, floor anchor, and listed Class A chimney. A standard wood stove without that listing can't legally be installed here.
Tight lots on the mountainside
Marshall's homes cling to steep hillsides with limited access, and the French Broad gorge sends cool, damp air through town — conditions that complicate how a chimney routes and how well it drafts. On a manufactured home, the listed Class A insulated chimney still has to run with the correct ceiling-support box, roof support, and spark arrestor and terminate at the right height, even on a cramped site up a cove. We plan that routing before we start, so the draft is right the first time.
The listing does the rest
The stove's data plate has to read manufactured-home approved — that's the line between legal and not, and both the Madison County inspector and your insurer will check it. The listing requires an outside-combustion-air duct to the firebox because the home is sealed tight, a permanent floor anchor, a hearth pad rated to the stove, and listed heat shields to hold the tight clearances to thin combustible walls. A conventional EPA stove qualifies for none of it.
Madison permit, tight-site timeline
We pull the Madison County permit and meet the inspector, about 25 minutes north of our Asheville showroom. Plan on two to three days for a proper install. Call (828) 545-0525 for a free in-home assessment.
Fireplace help in Marshall
We install and service fireplaces throughout Marshall and the rest of Madison County — just 25 minutes north from our Asheville-area showroom.