What size gas insert will fit my existing fireplace?
In Clyde a lot of homes are 1960s-to-'80s ranches with dated, factory-built fireboxes, so we start by reading the rating plate to see which inserts are listed for that box. Then it fits when its body clears the opening's four interior measurements with clearances — depth is usually the number that decides it on these prefabs.
Ranch-era boxes and their plates
Those older ranch-style Clyde homes often have a prefab firebox that's shallower than a masonry one, so depth is frequently the limiting measurement. Because it's a listed appliance, only certain inserts are approved to seat inside, and the model plate tells us which — we read it, then confirm front width, rear width, height, and depth with a tape. An insert is the upgrade that turns a dated decorative box into a real heater.
River humidity, mixed fuel
Clyde shares Canton and Waynesville's cold-air drainage, and river humidity rusts dampers and degrades masonry chimneys, so we check the flue and any masonry condition before sizing. Fuel is mixed here — natural gas on some streets, propane on others — and a propane insert is spec'd for LP. Connecting it is licensed gas work we permit through Haywood County and pressure-test.
Twenty-five minutes west
At over 2,600 feet Clyde holds cold longer than the lower valley towns, so an insert sized for genuine output is worth it — within whatever the firebox depth allows. We're 25 minutes west of the Emma Road showroom, an easy trip for a free in-home measure or a look at the inserts on display. Call (828) 545-0525.
Fireplace help in Clyde
We install and service fireplaces throughout Clyde and the rest of Haywood County — just 25 minutes west from our Asheville-area showroom.
Related questions
- What are the minimum firebox dimensions for a gas insert — will one fit a small fireplace?
- Can a gas insert go into a shallow firebox?
- How do I measure my fireplace for a gas insert?
- How much smaller than my fireplace opening will an insert's viewing window be?
- What is the surround or flashing panel on an insert and how is it sized?