Yes — Fletcher's 1990s subdivisions were often built with unfinished basements, and finishing one out with a gas fireplace is one of the more common projects we take on here. Natural-gas service runs through the I-26 corridor, so a sealed direct-vent unit typically extends off your existing meter, vents out a wall, and needs no chimney at all.
Builder-grade basement, real upgrade
A lot of Fletcher's 1990s subdivision homes came with a basic builder-grade firebox on the main floor and a basement left as storage. Turning that lower level into a heated family room with a direct-vent gas fireplace changes how the whole house lives, especially since these below-grade rooms run cold. Because the neighborhoods along the I-26 corridor sit on natural-gas mains, the fuel side is usually a straightforward line extension — we run and pressure-test it as the licensed gas contractor, which by NC law no builder or handyman can do for you. A model like the Napoleon Ascent 36 pairs everyday reliability with battery-backup ignition, so the room keeps heating during a power outage — the warmth WNC leaned on after Helene.
Homes and commercial spaces alike
Fletcher's Airport Road stretch draws commercial demand for gas fireplaces and outdoor features beyond the surrounding residential streets, and we handle both — a below-grade unit in a Cane Creek home or a linear fireplace in an office lobby. In a basement, the vent exits a sidewall on a daylight lower level or carries up through a buried one, with a power vent for a long run. Fletcher's steady new construction means we're often planning these while the basement is still framed, the cleanest time to do it. We pull the Henderson County permit and meet the inspector; the showroom is 20 minutes south. Call (828) 545-0525 for a free in-home assessment.
Fireplace help in Fletcher
We install and service fireplaces throughout Fletcher and the rest of Henderson County — just 20 minutes south from our Asheville-area showroom.