Yes — and in Weaverville the timing is often ideal, because so much of the new Reems Creek construction includes an unfinished basement waiting to be built out. A sealed direct-vent gas fireplace drops into that lower level cleanly, runs on the natural-gas main, and vents out a wall without a chimney. Older downtown homes work just as well.
Rough-in now, connect it right
On a new or recently built Weaverville home, the smart play is to plan the fireplace while the basement is still open framing. A builder can rough a chase and stub a gas line, but in North Carolina only a licensed gas contractor can actually connect and pressure-test the fuel — that's our lane, and it's the law. We take it from there: set the direct-vent appliance, run the line off the natural-gas main, pull the Buncombe County permit, and meet the inspector so the work is protected for your home sale and insurance. Building it in now also builds in backup heat, since a unit with battery-backup ignition keeps heating the basement through an outage — the grid-independent warmth Buncombe County valued after Helene.
Old downtown homes, same solution
Weaverville's older downtown houses tend to have an original masonry firebox upstairs that runs inefficiently and a basement that was never meant to be heated. Direct-vent solves both from below: a sealed, high-efficiency unit that warms the lower level without touching the aging chimney. Whether your basement is a Reems Creek walkout venting out a sidewall or a buried downtown cellar needing the pipe carried up — with a power vent on a long run — the path is straightforward. The north-facing valley here warms slowly in spring, which only lengthens the season that heat pays off. We're 15 minutes north on Emma Road; call (828) 545-0525 for a free in-home assessment.
Fireplace help in Weaverville
We install and service fireplaces throughout Weaverville and the rest of Buncombe County — just 15 minutes north from our Asheville-area showroom.