Clyde's older 1960s-to-80s ranch homes usually already have a firebox, so the common job — dropping a sealed insert into a dated fireplace — finishes in a single day and turns it into a real heater. A direct-vent gas unit is just as quick. Building a new wood fireplace with a full chimney runs two to three days.
Insert upgrades are the fast job here
Those ranch-era fireplaces around Clyde are prime insert candidates: the opening and the chimney already exist, so a sealed gas or wood insert goes in within a day, seals the draft, and starts producing real heat instead of sending it up the flue. Inserts commonly run 70 percent efficient or better, while the open masonry firebox it replaces can actually run a net heat loss — so it's a genuine performance upgrade, not just a facelift. When the existing chimney is sound and the fuel is close, it's a one-day visit start to finish.
River damp, fuel, and the Haywood permit
Clyde shares Canton and Waynesville's cold-air drainage, and river humidity rusts dampers and degrades masonry chimneys, so an older flue sometimes needs prep or a fresh liner before an insert can go in — that's time outside the install day. It's mixed-fuel country; on a propane home we tune the LP setup to burn clean. We pull the permit with Haywood County and meet the inspector, and that final inspection adds calendar days between the work and your first fire. As a licensed gas contractor, every line is permitted and pressure-tested. Call (828) 545-0525.
Fireplace help in Clyde
We install and service fireplaces throughout Clyde and the rest of Haywood County — just 25 minutes west from our Asheville-area showroom.
Related questions
- At what stage of new construction does the fireplace get installed?
- Can a fireplace be added to an existing home that never had one?
- Is adding a fireplace during a remodel more involved than in new construction?
- Can a fireplace be installed in an upstairs or second-floor room?
- What inspections happen after a gas fireplace is installed?