What size gas insert will fit my existing fireplace?
In Leicester many rural homes run on propane and some remote properties have limited electrical capacity, which points toward a Valor insert that needs no electricity at all. Fuel and power settled, the insert fits when its sealed body clears your firebox's four interior measurements with the required clearances.
When the house can't spare the power
Some of Leicester's remote large-lot properties have limited electrical capacity, and cold-air drainage runs these valleys 5 to 8 degrees below Asheville on clear winter nights. That combination makes Valor's radiant, millivolt inserts a strong fit — no blower, no circuit board, warmth that keeps coming through a grid-down stretch. Many of these homes are on propane, so the unit is set for LP with the correct orifice and pressure, and we permit through Buncombe County.
The opening still governs
Whatever the fuel or ignition, the insert has to physically seat in your firebox. We measure all four interior dimensions — front width, the tighter rear width, height, and depth — and the smallest one, with clearances, sets which model fits. Wood heat is popular out here too, so if you're converting a wood firebox to gas, the insert seats into that existing masonry opening.
Fifteen minutes west
Leicester is 15 minutes west of the Emma Road showroom, so a free in-home measure is easy to schedule, and a surround panel frames whatever gap is left around your opening. Call (828) 545-0525, and we'll confirm your fuel and power situation while we're there, so the model we recommend actually suits the house.
Fireplace help in Leicester
We install and service fireplaces throughout Leicester and the rest of Buncombe County — just 15 minutes west from our Asheville-area showroom.
Related questions
- What are the minimum firebox dimensions for a gas insert — will one fit a small fireplace?
- Can a gas insert go into a shallow firebox?
- How do I measure my fireplace for a gas insert?
- How much smaller than my fireplace opening will an insert's viewing window be?
- What is the surround or flashing panel on an insert and how is it sized?