Why won't my gas fireplace light after a power outage?
In Clyde, a lot of the fireplaces sit in 1960s-to-80s ranch homes and are simply dated — and older units are more likely to trip you up after an outage. Depending on the vintage, yours may run a constant standing pilot that ignores the grid, or an early electronic ignition whose aging board and batteries are the real weak point.
Pin down the vintage
Fireplaces from that era go both ways. A dated gas log set with a standing pilot keeps a flame lit continuously, so an outage shouldn't affect it — a no-light there means a pilot or thermocouple problem. An older electronic-ignition unit depends on batteries and a control board: replace the cells at the receiver and remote, then let the board reset its lockout. On an aging unit, though, the electronics themselves may be near the end.
River humidity and dated parts
Clyde shares the cold-air drainage and river humidity of Canton and Waynesville, and that damp rusts dampers, degrades masonry chimneys, and works on ignition contacts over the years. A dated fireplace that won't respond to new batteries has often just reached the point where a component finally corroded through. That's frequently when homeowners here weigh an insert upgrade — a sealed unit runs far more efficiently and, in a millivolt or battery-backup model, keeps heating during the next outage.
Repair or upgrade, honestly quoted
Whether it's a repair or a new insert, connecting the gas is licensed work we permit through Haywood County and quote upfront — and we'll tell you honestly when a dated unit is worth fixing versus replacing. Clyde is about 25 minutes west of the Asheville showroom. Call (828) 545-0525.
Fireplace help in Clyde
We install and service fireplaces throughout Clyde and the rest of Haywood County — just 25 minutes west from our Asheville-area showroom.
Related questions
- Do gas fireplaces have batteries, and can dead batteries stop the fireplace from working?
- How do I tell whether my gas fireplace has a standing pilot or electronic ignition?
- Why won't my gas fireplace turn on at all?
- How do I reset my gas fireplace's ignition control module?
- Why won't my fireplace light even after I changed the batteries in the remote and receiver?